JeffTron AEP Mosfet

Professionally designed mosfet with cabling designed for airsoft electric pistols. The device increases the rate if fire of the weapon and the endurance of the battery compared to the original cabling in the weapon. Allows the use of 7.4V Li-pol batteries. Can be installed without modification to the following AEPs:
Cyma CM.030
Cyma CM.121
Cyma CM.122
Cyma CM.123
Cyma CM.125
Cyma CM.126
Cyma CM.127
Cyma CM.128
Tokyo Marui Glock 18C AEP
Tokyo Marui Beretta M93R AEP
Tokyo Marui Beretta M9A1 AEP
Tokyo Marui HK USP AEP
Umarex HK USP AEP
Double Eagle M81 USP

SPECIFICATIONS:
- Very small device dimensions - used Micro mosfet II
- Ready-made custom cabling allows quick and easy installation in the gun. Just power the wires to the motor and the trigger contacts
- Power cables with silicone insulation with a cross-section of 0.5 mm2 (210 mm from the mosfet) and blue cables with PVC insulation with a cross-section of 0.25 mm2 (110 mm from the mosfet) are soldered to the device
- The JST-SYR 2 pin connector is used to connect the battery
- covered with paint, which protects against humidity
- If you want to use your own wires, choose Mikro mosfet II without cabling
- Use for any AEP with the highest upgrade - dimensioned up to springs up to m160 (corresponds to a current of 75A for a single shot or 25A firing dose for a maximum of 30s)
- It is recommended to use a 7.4V lipol battery, however the device is designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- 6-wire connection
- Device size 15x7x5mm
- Trigger contacts do not burn
- No quiescent current is being drawn
- Due to the principle of operation of the AEP weapon mechanism, the piston stops in a random position in AUTO mode
- For the correct function of this device, it is necessary to have a functional cut-off, tappet platte, reversing latch, trigger and trigger stop (locked) in the gearbox, ie as in the standard gearbox

PRODUCT MANUAL:

• Product manual -> here

PACKAGING:
- Mosfet with power cabling and JST-SYR connector
- Installation Manual

WARNING: To install this device, you need an expert who must be able to solder and disassemble an AEP weapon. Never use a transformer solder!