JeffTron Active brake II with wiring

Professionally designed mosfet with active engine braking designed for airsoft electric weapons. The piston is not partially extended during semi-firing, the spring does not get tired, the internal parts are not stressed and the nozzle largely locks the chamber. For high-cadence weapons, it solves the problem of multiple shots in the semi-firing mode. The device increases the cadence of the weapon and the endurance of the battery compared to the original cabling in the weapon.

SPECIFICATIONS:
- Separate device without cables, cables with a maximum cross-section of 1.5 mm2 can be used for the power circuit and for signal circuits with a maximum cross-section of 0.5 mm2)
- The device is powered by 4 wires with rigid MPPE insulation with a cross-section of 1.5 mm2 (AWG16) and two blue wires with a cross-section of 0.34 mm2 (AWG22) with a length of 500 mm.
- Encapsulated in a varnish that protects against the ingress of water into the device
- If you want to use your own wires, choose the variant without cabling
- Designed for springs up to M210 (corresponds to a current of 150A for a single shot or 50A firing dose for a maximum of 30s))
- Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V))
- After opening the contacts, the excess energy of the motor is used to stop it. The braking effect is strongest with a load motor with neodymium magnets.)
- 6-wire connection)
- Device size 35x13x7mm)
- Trigger contacts do not burn)
- No quiescent current is being drawn)
- Due to the principle of operation of the AEG weapon mechanism, the piston stops in a random position in AUTO mode)
- For the correct function of this device, it is necessary to have a functional interrupter, a switch slide, a reversing latch, a trigger and a trigger stop (locked) in the gearbox, ie as in the standard gearbox

• PRODUCT MANUAL -> here

PACKAGING: Device with powered cabling, DeanT male connector, 30A mini plug fuse, 4x faston socket, 6x black tube 3.2mm length 20mm, 3x black tube 4.8mm length 20mm, Installation manual

WARNING: To install this device, you need an expert who must be able to solder and disassemble an AEG weapon. Never use a soldering iron!