JeffTron Leviathan V2 to stock without trigger

Professionally designed and microprocessor-controlled mosfet with wireless technology. It adds new ways of firing, a smooth change in firing speed, pre-tensioning of the piston, active engine braking, low battery indication, statistics, ... Everything is controlled via an application in the smartphone (iOS and Android). Fully integrated device inside the v.2 gearbox instead of the original trigger contacts. Finished cabling adapted for the battery in the stock with a DeanT connector - there is no need to solder anything.

MAIN FEATURES:
- Adds new firing modes independently for each switch position (SAFE - SEMI - AUTO) - Adjustable burst (range 2 - 20 rounds)
- Reduction of cadence by up to 40% with a pause between shots. As a result, the shot has a quick response to the trigger, as with a real weapon
- Adjustable active engine braking force with the possibility of switching it off
- Piston pre-cocking function for immediate firing in SEMI firing mode
- Shot delay function, when it is not possible to fire again for a certain time. It is for simulation of kickback or reloading (range 0.1 - 4.0 s)
- The electronic fuse sets the sensitivity of the current protection
- Low battery indication for 2S - 4S li-pol and 3S - 4S li-fe
- Screen with statistics from shooting with current consumption of the motor and the temperature of the mosfet allows you to fine-tune the assembly of the gearbox
- Display the current cadence of the weapon
- The application displays the current battery voltage. The colored bar indicates its state of charge
- Save parameters to profiles for fast loading
- Update fixes bugs and adds new features for devices
- Error log shows the history of errors recorded by Leviathan - V2
- For greater security, it is possible to turn off the wireless connection via the firing switch (can be deactivated)
- Leviathan - V2 monitors the passing current, voltage and temperature to avoid damage if something bad happens
- Uses vibration and motor beeps in the stock to alert the user
- The setting change is immediately saved to Leviathan's memory - V2, so programming is not lost when disconnected from the smartphone or battery

SHOOTING MODE SELECTION:
Independent of the switch position (SAFE - SEMI - AUTO)
- SAFE: does not respond when the trigger is pressed.
- Semi: fires once when the trigger is pressed.
- Semi / BurstX: short press fires once, hold to fire the selected dose.
- Binary trigger: Fires once when the trigger is pressed and again when the trigger is released.
- BurstX: Fires a dose when the trigger is pressed.
- BurstX + BurstY: short press fires burstX, long press fires sum burstX + burstY.
- Burst / Full: a short press of the shutter button fires burstX, a long press starts automatic firing.
- Full: the weapon fires until the trigger is released (AUTO).

TECHNICAL SPECIFICATIONS:
- Easy installation inside the v.2 gearbox, which is according to the switch concept designed by Tokio Marui
- In most cases, no modifications are required in the gearbox or Leviathan - V2
- For perfect timing of the shot, a microswitch closed with each revolution of the piston wheel
is used - Thanks to advanced electronics, the Leviathan - V2 can be used in a weapon with any common upgrade and cadence, including DSG wheels
- Complete cabling allows quick and easy installation in the weapon, it is long enough for all types of weapons with a battery in the back. No need to solder
- Power cables with a cross-section of 1.5 mm2 (AWG16) with thin and rigid MPPE insulation, blue cable with a cross-section of 0.34 mm2 (AWG22) with MPPE insulation
- The power cables have an outer diameter of only 2.06 mm and a blue 1.24 mm
- The length of the wires between the end of the gearbox and the connector is 290mm
- Encapsulated in a varnish that protects the device against water damage
- For proper pre-cocking function, it is necessary to have a functional reverse latch
in the gearbox - Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- The device is equipped with a 40A fuse
- The device increases the rate of fire of the weapon and the battery life compared to the original cabling in the weapon
- With active engine braking, the piston is not partially cocked during firing, the spring is not being worn by partial compression, the internal parts are not stressed
- For high-rate of fire weapons, active braking solves the problem of multiple shots in semi-shooting mode.
- The braking effect of the motor is strongest with a high torque motor with neodymium magnets
- Remove from the gearbox: the circuit breaker, the trigger contacts and the trigger stop - with the Leviathan - V2 you will not need them.

LINKS:

• Leviatan by Jefftron mobile application for iOS or Android -> here

• Product manual -> here

PACKAGING:
- Leviathan - V2 electronic module with complete cabling
- bolt with washer for securing the device in the gearbox
- Adjusting screw for adjusting the trigger operation
- Black sticker Leviathan 40 mm
- Foam to secure the device in the gearbox
- Installation instructions

SAFETY WARNING:
- You must have technical knowledge to install the device in a gearbox!
- Please read and follow all instructions to avoid damage to the device.
- Short-circuiting or incorrect connection of the battery will immediately damage the device, which is not covered by the warranty. It can also ignite or explode the battery!
- Disconnect the battery when you are not using the weapon! Otherwise, you will completely discharge the battery. The device still draws a small amount of current.
- Do not connect the battery if the weapon is aimed at you, another person or an animal!
- Do not modify, repair, prevent spillage or heat shock Leviathan - V2.