JeffTron Micro active brake II

Professionally designed mosfet with active engine braking designed for airsoft electric weapons. The piston is not partially extended during semi-firing, the spring does not get tired, the internal parts are not stressed and the nozzle largely locks the chamber. For high-cadence weapons, it solves the problem of multiple shots in the semi-firing mode. The device increases the cadence of the weapon and the endurance of the battery compared to the original cabling in the weapon.

SPECIFICATIONS:
- Very small device size, fits almost anywhere
- Separate device without cables, cables with a max. Cross-section of 1.5 mm2 can be used for the power circuit and 0.5 mm2 for cables with a max. Cross-section
- Suitable for service centers, if you are not sure about soldering the wires to the board, choose the variant with cabling and accessories.
- Designed for springs up to m160 (corresponds to a current of 75A for a single shot or 25A firing dose for a maximum of 30s)
- Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- After opening the contacts, the excess energy of the motor is used to stop it. The braking effect is strongest with a load motor with neodymium magnets.
- 6-wire connection
- Device size 27x10x7mm
- Trigger contacts
do not burn - No quiescent current is being drawn
- Due to the principle of operation of the AEG weapon mechanism, the piston stops in a random position
in AUTO mode - For the correct function of this device, it is necessary to have a functional interrupter, switch slide, reversing latch, trigger and trigger stop (locked) in the gearbox, ie as in the standard gearbox

PRODUCT MANUAL:

• Product manual -> here

PACKAGING: equipment, tube, and installation manual

WARNING: To install this device, you need an expert who must be able to solder and disassemble an AEG weapon. Never use a soldering iron!