JeffTron Micro active brake II with wiring

Professionally designed mosfet with active engine braking designed for airsoft electric weapons. The piston is not partially extended during semi-firing, the spring does not get tired, the internal parts are not stressed and the nozzle largely locks the chamber. For high-cadence weapons, it solves the problem of multiple shots in the semi-firing mode. The device increases the cadence of the weapon and the endurance of the battery compared to the original cabling in the weapon.

SPECIFICATIONS:
- Very small device size, fits almost anywhere
- Pre-prepared cabling allows faster and easier installation into the weapon, it is long enough for all types of weapons. Just shorten the wires to the required length and power the connectors (included)
- The device is powered by 4 wires with rigid MPPE insulation with a cross-section of 1.5 mm2 (AWG16) and two blue wires with a cross-section of 0.34 mm2 (AWG22) with a length of 500 mm.
- Encapsulated in a varnish that protects against the ingress of water into the device
- If you want to use your own wires, choose the variant without cabling
- Designed for springs up to m160 (corresponds to a current of 75A for a single shot or 25A firing dose for a maximum of 30s)
- Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- After opening the contacts, the excess energy of the motor is used to stop it. The braking effect is strongest with a load motor with neodymium magnets.
- 6-wire connection
- Device size 27x10x7mm
- Trigger contacts
do not burn - No quiescent current is being drawn
- Due to the principle of operation of the AEG weapon mechanism, the piston stops in a random position
in AUTO mode - For the correct function of this device, it is necessary to have a functional interrupter, switch slide, reversing latch, trigger and trigger stop (locked) in the gearbox, ie as in the standard gearbox

• PRODUCT MANUAL -> here

PACKAGING: Device with powered cabling, DeanT male connector, 30A mini plug fuse, 4x faston socket, 6x black tube 3,2mm length 20mm, - 3x black tube 4,8mm length 20mm, Manual to install

WARNING: To install this device, you need an expert who must be able to solder and disassemble an AEG weapon. Never use a soldering iron!