JeffTron Mosfet V3

Professionally designed mosfet without cabling designed for airsoft electric guns. The device increases the rateof fire of the weapon and the endurance of the battery compared to the original wiring in the weapon. Fully integrated device inside the v.3 gearbox instead of the original trigger contacts according to the Tokyo Marui standard.

SPECIFICATIONS:
- Built-in mosfet on switching contacts from SHS
- Easy installation inside the gearbox v.3
- Separate device without cables, cables with a max. Cross-section of 1.5 mm2 can be used for the power circuit and 0.5 mm2 for cables with a max. Cross-section
- Suitable for service centers, if you are not sure about soldering the wires to the board, choose the variant with cabling and accessories.
- Designed for springs up to m160 (corresponds to a current of 75A for a single shot or 25A dose firing for a maximum of 30s). For higher loads, use Mosfet II (located outside the gearbox)
- Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- Trigger contacts do not burn
- No quiescent current is being drawn
- Due to the principle of operation of the AEG weapon mechanism, the piston stops in a random position in AUTO mode
- For the correct function of this device, it is necessary to have a functional interrupter, a switch slide, a reversing latch, a trigger and a trigger stop (locked) in the gearbox, ie as in the standard gearbox

PRODUCT MANUAL:

• User guide -> zde

PACKAGING:
- mosfet on switching contacts
- trigger shuttle
- black tube 3,2mm length 20mm
- installation manual

WARNING: To install this device, you need an expert who must be able to solder and disassemble an AEG weapon. Never use a transformer solder! Despite all efforts, 100% compatibility of the device with all version 3 gearboxes cannot be guaranteed. For most commonly available and widespread brands, Mosfet - V3 can be installed without major modifications.